Thursday, May 17, 2018

Mechanical Engineers’ Handbook Instrumentation, Systems, Controls, and MEMS Third Edition By Myer Kutz

Mechanical Engineers’ Handbook Instrumentation, Systems, Controls, and MEMS Third Edition By Myer Kutz
Contents:
PART 1 INSTRUMENTATION
1. Instrument Statics
2. Input and Output Characteristics
3. Bridge Transducers
4. Measurements
5. Temperature and Flow Transducers
6. Signal Processing
7. Data Acquisition and Display Systems
8. Digital Integrated Circuits: A Practical Application
PART 2 SYSTEMS, CONTROLS, AND MEMS
9. Systems Engineering: Analysis, Design, and Information Processing for Analysis and Design 
10. Mathematical Models of Dynamic Physical Systems
11. Basic Control Systems Design
12. Closed-Loop Control System Analysis
13. Control System Performance Modification
14. Servoactuators for Closed-Loop Control
15. Controller Design
16. General-Purpose Control Devices
17. State-Space Methods for Dynamic Systems Analysis
18. Control System Design Using State-Space Methods
19. Neural Networks in Feedback Control Systems
20. Mechatronics 
21. Introduction to Microelectromechanical Systems (MEMS): Design and Application 
Preface:
The second volume of the third edition of the Mechanical Engineers’ Handbook (‘‘ME3’’) is comprised of two major parts: Part 1, Instrumentation, with eight chapters, and Part 2, Systems, Controls, and MEMS, with 13 chapters. The two parts are linked in the sense that most feedback control systems require measurement transducers. Most of the chapters in this volume originated not only in earlier editions of the Mechanical Engineers’ Handbook but also in a book called Instrumentation and Control, which was edited by Chester L. Nachtigal and published by Wiley in 1990. Some of these chapters have been either updated or exten sively revised. Some have been replaced. Others, which present timeless, fundamental concepts, have been included without change.1 In addition, there are chapters that are entirely new, including Digital Integrated Circuits: A Practical Application (Chapter 8), Neural Net works in Control Systems (Chapter 19), Mechatronics (Chapter 20), and Introduction to Microelectromechanical Systems (MEMS): Design and Application (Chapter 21)

Download



***********************

No comments:

Post a Comment

DMCA

Disclaimer for MEP Engineering Café (“MEP Engineering Café”) respects the intellectual property rights of others and expects its users to do the same. In accordance with the Digital Millennium Copyright Act of 1998, the text of which may be found on the U.S. Copyright Office website at http://www.copyright.gov/legislation/dmca.pdf, MEP Engineering Café will respond expeditiously to claims of copyright infringement committed using the MEP Engineering Café service and/or the MEP Engineering Café website.




DMCA.com Protection Status

Social Media

Find your book

Featured Post

 Three-Dimensional Integrated Circuit Design EDA, Design and Microarchitectures by Yuan Xie, Jason Cong and Sachin Sapatnekar Content  1 Int...